Seiko Spring bars original for Seiko Diver rubber watchbands. Spring bars are used to connect your watch band to your watch or connect a watch buckle or clasp to your watch band. The ends of the pins are flanged and have a spring at the end of the bar that allows for easy removal and installation. Our spring bar pins are made in stainless steel. Size: 22mm. To find out which size you need, measure the length of your old spring bar or if you are replacing a pin on a leather band, the inside of the band usually has the size imprinted on it or you can measure the distance between the watch case lug to lug (the area between where watchband goes). Most watch pins are measured in millimeter sizes. Use a ruler or a metric (mm) units to measures the pin or the distance between the case or lugs of the watch. Fits: C220FS Comes with installation instructions.
List Price:
Our Price:
$3.75
You Save:
Product Details
Package Length:
3.9 inches
Package Width:
2.7 inches
Package Height:
0.1 inches
Package Weight:
0.05 pounds
Average Customer Rating:
based on 1 reviews
Features
Seiko Spring Bar for Divers Watch Band Original
Size: 22mm
Stainless Steel
Fits: C220FS
Set of 2 Pins
Customer Reviews
Average Customer Review: ( 1 customer reviews )
Write an online review and share your thoughts with other customers.
Most Helpful Customer Reviews
1 of 1 found the following review helpful:
Stronger pins for stronger hold Dec 06, 2010
By Richard Lee
"What is Hip?"
I had pins for the watch in question but they were thin and weak. I was concerned the watch could slip off and be lost if they broke. It has happened with a watch I once had. These beefy looking pins solve the problem. Be advised that some watchbands will not accept a pin as fat as these are.
based on 1 reviews
